runninglobi.blogg.se

Saniflo toilet installation diagram
Saniflo toilet installation diagram










saniflo toilet installation diagram saniflo toilet installation diagram
  1. #SANIFLO TOILET INSTALLATION DIAGRAM INSTALL#
  2. #SANIFLO TOILET INSTALLATION DIAGRAM PRO#

Please note that the vent system should be a two-way air vent. All plumbing codes require connection to a vent system. This unit has been designed with a vent connection on the lid. A non-return valve (included in assembly) prevents back flow into the unit.

#SANIFLO TOILET INSTALLATION DIAGRAM PRO#

The discharge elbow on top of the Sanibest Pro can be rotated 360 degrees depending on the discharge installation. The wastewater from other sanitary fixtures is discharged into the Sanibest Pro via two 2-inch inlets on either side of the housing. This base should be made out of a 2”x 8” on edge to allow for the installation of a p-trap and the required 1/4” per foot gravity flow towards the pump unit. When adding a bathtub/shower, a base will have to be constructed. In addition, the Sanibest Pro will also discharge gray water from a variety of other sanitary fixtures such as: a sink, a bath/shower, a urinal and even a washing machine (indirect connection). A normal operating cycle for the Sanibest Pro takes about 10 - 12 seconds depending upon the discharge pipe run configuration. Once the water level in the container goes down, the micro switch deactivates. The unit pumps the effluent upward to 25 feet and/or 150 feet horizontally (with gravity fall). The reduced solids are picked up at the bottom and the impeller mounted beneath the motor ejects the waste. Water and organic waste matter enter the chamber and are reduced to slurry as the blades rotate at 3600 RPM. The moving parts therefore are kept to an absolute minimum. A common spindle/shaft drives the impeller and the blades. The motor is sealed for life in an oil filled enclosure.

saniflo toilet installation diagram

When the flush is activated, the water flowing into the Sanibest Pro activates a micro switch in the pressure chamber, which in turn starts the motor. The inside of the Sanibest Pro comprises of a pressure chamber, which starts and stops the unit, and the motor, which drives the stainless steel cutting blade and the pump. The Sanibest Pro is designed to handle sanitary products that may have been flushed down the toilet such may consist of condoms, sanitary napkins, q-tips, dental floss, etc. It incorporates a grinder system which is ideal for uncontrolled environments in both residential and commercial applications (ie.

#SANIFLO TOILET INSTALLATION DIAGRAM INSTALL#

The Sanibest Pro is a 1 HP pump system used to install a complete bathroom up to 25 feet below the sewer line, or even up to 150 feet away from a soil stack.












Saniflo toilet installation diagram